Make sure you can see the camera through the web interface.
If you can see the image then type in “http://<ip_address_of_camera>/__live.jpg?&&&” without the quotes and replace “<ip_address_of_camera>” with the actual ip address of the camera. If you see a single snapshot of the camera then you are ready to program the DVR
/NVR.
In the ETV software make sure that you have version 4.03.xxxx or greater.
Left click on the “Settings” button.
From the pull down menu select the camera that you would like to assign the IP camera to.
Put a check in the check box labeled “Network Camera”.
Left click on the “Settings” button next to the “Network Camera” check box.
On 4.02.0030 you select “Http Pull” on 4.03.xxxx or greater you will select “HTTP”
In box labeled “Address” you will enter the IP address of the camera.
In the box labeled “URL” you will enter “/__live.jpg?&&&”. Make sure you have the front slash. There are 2 underbars ”_” before live.jpg and you have to have the “?&&&” after.
Left click on the “OK” button.
Left click on the “Apply”
Select the camera from the pull down menu and make sure you see video, once you see video left click on “OK” and your done.
